Change I can believe in: Chain and Sprocket

[SonicGuppy]

Last week I fired in a new set of Sprocks and a Chain. I found the work simple and not overly hard. I'd read another post on it and took the suggestion of the 2x4 in the rear rim

http://www.zrxoa.org/forums/showthread.php?t=258978

That did the trick. The Torque on the nut wasn't that tough, though I used a 3' section of pipe.

Install was simple, I used CP-Moly Grease on the Output Shaft and inner of the Front Sprock.

As for the Chain, I looked at Scrabble's post and tried it,

http://www.zrxoa.org/forums/showthread.php?t=187885

The install took all of 10 minutes! That beats clunky chain tools by a yard!

Overall, the job took me about 4 hours, the Rear Rim install and Chain Tension gobbling up the better part of an hour. Other than that, simple stuff.

Thanks to Kwick, Scrabble and Dave Ditner for answers!