Search:

Type: Posts; User: trippin green

Search: Search took 0.09 seconds.

  1. Replies
    28
    Views
    1,758

    Re: Delkevic exhaust

    Yes, you are correct about the joint at the muffler, that is the typical connection. What is reversed is the mid pipe to collector connection.

    Good to hear you guys have had good results though....
  2. Replies
    28
    Views
    1,758

    Re: Delkevic exhaust

    A question for anyone who got the Delks, all the pictures show the mid pipe fits inside the collector instead of outside like most. This shouldn't seal as well (shows they know this as they supply a...
  3. Replies
    19
    Views
    959

    Re: New guy, Hello, help ID bike?

    Kwiks chain tamer.... mmm candy
    Machined my own CRK
    Re-torqued and lock tight the Alternator coupler bolt

    Bike is tight and smooth.
  4. Replies
    19
    Views
    959

    Re: New guy, Hello, help ID bike?

    Starter tensionator not installed, just ordered.

    316285316286316287
  5. Replies
    19
    Views
    959

    Re: New guy, Hello, help ID bike?

    Fixed got all the travel back. The tab was just below the notch.
  6. Replies
    19
    Views
    959

    Re: New guy, Hello, help ID bike?

    Just checked, that and blinker fluid were right at the high line, muffler bearing is all good too :nana:
  7. Replies
    19
    Views
    959

    Re: New guy, Hello, help ID bike?

    Good catch, it must be clocked wrong, its making the cable to tight when suspension is extended. I'll fix that one tonight.

    Also, I think one of the POs ran it with a round headlight, it has...
  8. Replies
    19
    Views
    959

    Re: New guy, Hello, help ID bike?

    Maintenance updates

    Unwired and removed USB port
    Removed and capped failed breather filter from air injection T's.... Runs much smoother and pops less now. (might get some blingy block off...
  9. Replies
    19
    Views
    959

    Re: New guy, Hello, help ID bike?

    Yeah, it has a Brembo clutch master so that's the stock switch connector with an LED in as a jumper, so start safety logic and ecm would think clutch is always engaged (does this effect over run on...
  10. Replies
    19
    Views
    959

    Re: New guy, Hello, help ID bike?

    Thanks for lookin folks.

    The bike is great, set up well and runs great. RJC65 I'd definitely like to tag along for a ride some time and get to know some fun local roads. I commute mostly, but...
  11. Replies
    19
    Views
    959

    New guy, Hello, help ID bike?

    Hello, great forum, thanks in advance for those who manage moderate and support. The information I've found has been hugely helpful already.

    I just picked up this 2005 ZRX1200 from a guy south of...
Results 1 to 11 of 16
Powered by vBulletin® Version 4.1.7
Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.
All times are GMT -4. The time now is 04:34 PM.
vBulletin 4.0 skin by CompleteVB